noobs VS rpi-eeprom

Is there any way you can access the terminal? Like does it take you to the login screen at all? If so, you can mount a different SD card partition (try to mount /dev/mmcblk0p5/ or /dev/sda1/), reboot, and it should work (only if you somehow mounted the recovery partition by accident). This page may be helpful for you in understanding the partition issue and finding which partition to mount if it’s not one of those two above.

The secondary reason I advise against NOOBS is that it has been removed from the downloads page (see here for the GITHUB repository) - the primary is that it does give issues with updates / upgrades and gets in the way. It's much simpler to use a 16Gb or 32Gb card given the way the costs have dropped.

https://github.com/raspberrypi/noobs/issues/634 all the way back in 2021

First off, what do we need? - A Raspberry Pi (a Raspberry Pi 3 Model B V1.2 in my case) - A SD-Card reader/writer - Raspberry Pi Imager software - CODESYS - CODESYS Control for Raspberry Pi MC (SL) or No SL - Factory IO (Ultimate or Modbus OPC edition)

start4.elf is not compatible USB-MSD boot requires newer software Get the latest software from https://www.raspberrypi.org/downloads.

Noobs from RaspberryPi can easily be modified like changing the logo Here is a link to the github repository: noobs

a. Download Raspian and upload it to your SD card using Balena Etcher.

I don't have Pi 5 to check this, but from what I've read, it does not support PPS. And such support is required; otherwise, even with a source that supports PPS, the connection will behave in a non-PPS fashion.

Apparently, cable quality is also demonstrating itself to be a significant factor in the Pi 5 power supply environment.

Regarding both these points:

https://github.com/raspberrypi/rpi-eeprom/issues/497

I should note, I updated the eeprom, USB hub, and network firmware using the images provided from the following repository: https://github.com/raspberrypi/rpi-eeprom. So it certainly isn't a corrupted eeprom chip, and if it was I wouldn't be able to boot the old installation I pulled from my backup drive.

Its a known issue with the current Pi 4 boot firmware. The net install option is trying to look for a keyboard and gets confused with some HIDs.

I was working on a final project for my class and needed an adc. So I ordered an ADS1115 and I had to solder the pins onto it. I've never soldered before, but I tried my best. Didn't look amazing, but didn't look like any pins were getting shorted so I plugged it in to the Pi. I then noticed that my ssh disconnected and couldn't reconnect. Tried plugging in the HDMI and there was no video output. I tried flashing a new OS onto it, didn't work. Tried EEPROM recovery from here and it didn't work. So I think I killed the Pi. It doesn't feel like it's getting warmed up or anything.

See https://github.com/raspberrypi/rpi-eeprom/blob/master/firmware/release-notes.md

I try to reset the pi as factory settings (following this github advice). I use pi-imager to set my SD card to lead the pi using USB boot priority and plug a USB key with raspbian OS (no desktop) and now getting green screen when booting. Think that the pi is dead.

I think it was this one:

https://github.com/raspberrypi/rpi-eeprom/blob/master/firmwa...

I had the same problem as you, updated my eeprom and the problem was fixed

Firmware: https://github.com/raspberrypi/rpi-eeprom/releases/tag/v2020.09.03-138a1