itlwm VS ThinkPad-T460s-macOS-OpenCore

Try use airporttlwm.kext. Here

Intel AC 8260 WiFi+BT - AirportItlwm + IntelBluetoothFirmware

This was just released : https://github.com/OpenIntelWireless/itlwm/releases

Yeah there is. I think it’s itlwm.

What part I got an issue with: have to set SecureBootModel to 'Disabled' since i am using AirportItlwm for monterey

Wifi is a little unreliable a few minutes after boot (waiting for AirportItlwm to be stable release)

For about a year I've been using this config on my ThinkPad. On the whole, I've had no issues with it and everything is still working fine.

I am planning on installing Monterey on an external SSD to boot on my Late 2015 iMac, Late 2009 iMac, and Lenovo t460s (as an OpenCore Hackintosh). I checked enable native models on OpenCore (I couldn’t find clear info online but I figured better safe than sorry to check that box for what I hope was allowing OpenCore to also boot on the Late 2015 which natively supports Monterey). My issue is that the guide I’m following for the T460s OpenCore uses a preconfigured EFI folder and I’m unsure how to merge it with the OpenCore Patcher created one to allow for booting on both the 2009 iMac (9,1) and T460s (assuming I don’t need to do anything else for the late 2015)?

[https://github.com/simprecicchiani/ThinkPad-T460s-macOS-OpenCore]

Bluetooth doesn’t work (my fault for using a Prebuilt).

I have installed Hackintosh BigSur on my x260 as per this guide https://github.com/simprecicchiani/ThinkPad-T460s-macOS-OpenCore/

Hey, I'm following this guide https://github.com/simprecicchiani/ThinkPad-T460s-macOS-OpenCore for installing Hackintosh on my x260.

I believe there is a problem with some patches or kexts. I used this repo to get all the necessary EFI files.

Using a Broadcom BCM94360CS2 and based on this repo.

Hi guys! So I installed Monterey using this guide on my ThinkPad X260, and everything is working great (including GPU acceleration and Intel WLAN), except the dock and left-side USB ports. The USB port on the right side is working fine, but the two ports on the left side aren’t even recognised by the USBmap tool from the Dortania guide. Any ideas on how to make the USB ports work? Thanks in advance!