homebridge VS shelly-homekit

I've been trying to set up Homebridge on Hyper-V using the guide provided here: https://github.com/homebridge/homebridge/wiki/Install-Homebridge-on-Windows-10-Using-Hyper-V

Search on the main page (https://homebridge.io/) for plugins that work with the devices you can't add directly to homekit. If you find what you need then you're probably good to go ahead with it, though not all the plugins are completely reliable. Sometimes there's more than one for a given device though.

Start here: https://homebridge.io/

I'm new to Node-Red and programming in general. I'm trying to pass humidity and temp reading from my Pimoroni Enviro Indoor to my HomeBridge setup. The Enviro Indoor will POST every 5 minutes a JSON that looks like this

You could potentially use the requisite Shelly for your use case and install this firmware on it to expose it to HomeKit as a lock

As far as I know you can flash a software on the relays: https://github.com/mongoose-os-apps/shelly-homekit And make them homekit compatible. Here is the video: https://youtu.be/BZc-kp4dDRw Just make sure to use correct download for your device

Shelly Firmware

Shelly one flashed with HomeKit. So easy cheap and one of the most reliable HomeKit devices I have. Watch the video https://github.com/mongoose-os-apps/shelly-homekit

The relay itself doesn’t matter especially given the fact that it’ll be on/off only, so I’d recommend a Shelly Plus 1 flashed with firmware to get it into HomeKit incredibly easily. The contactor doesn’t need to be anything fancy, just needs to be rated appropriately for the load at hand!

I use Shelly relays flashed with firmware (I prefer it over Homebridge) and automations to do this. It keeps the „normal“ look of the lightswitches and won’t cut power to the bulbs. Plus you can configure the different modes for the lightswitches! Check out the link for edge/toggle/etc. 👍🏼

If your light switch is a 2 gang switch I’d recommend picking up a Shelly 2.5, a Shelly 1 Plus, or Plus 1PM for single switches and flashing them with this firmware.

Alternatively, a more cost efficient option could be LED strips of your choice paired with a Shelly RGBW2 flashed with firmware.

The only thing I could think of is using something like a Shelly Plus 1 in HomeKit (firmware/Homebridge paired to a strike of the appropriate voltage.