gcc_termux VS rtl_433

I'm attempting this on a Pixel 3. I'm going to try the instructions in the gcc-termux README.md

You can also compile it by yourself following the guidance here: https://github.com/its-pointless/gcc_termux/issues/135

Did you add the It's Pointless repo?

Add It's Pointless

The right link is https://github.com/its-pointless/gcc_termux.

This said, most compilation issues can be fixed by adding It's Pointless Repo, install libgfortran5 and issue a setupclang-gfort-11 and try again.

If not found, install It's Pointless repo and try again.

gcc from It's Pointless repo

And there's a multiformat receiver block too: https://github.com/merbanan/rtl_433

pi@pi4b8:/etc/systemd/system $ cat rtl_433.service # based on https://github.com/merbanan/rtl_433/issues/1651 [Unit] Description=RTL_433 service script StartLimitIntervalSec=5 Documentation=https://github.com/merbanan/rtl_433/README.md After=syslog.target network.target [Service] Type=exec ExecStart=/usr/bin/rtl_433 -C si -F mqtt # Restart script if stopped Restart=always # Wait 30s before restart RestartSec=30s # Tag things in the log # View with: sudo journalctl -f -u rtl_433 -o cat SyslogIdentifier=rtl_433 StandardOutput=syslog StandardError=syslog [Install] WantedBy=multi-user.target

For example, rtl_433 has the spec for an X10 sensor say I know what data I want to put where, is there some tool/site I could enter in what the "specifications" of the signal waveform are and the data I want to send as a byte-string or binary-string and it would create a playable .sub file for me?

For "outdoor distances" I'd probably stick to something LoRa or 433MHz based. YoLink has quite a few options using the LoRa protocol. I use basic 433Mhz based AcuRite sensors paired with an RTL-SDR dongle connected to a machine running RTL_433, and use Home Assistant to trigger automations and alerts.

866-868MHz is SRD/ISM band (in UK/EU). Can be things like energy meters, TPMS, medical devices etc. Try rtl_433 on it.

I'm trying to add a Honeywell doorbell to Home Assistant by using the RTL-433 GitHub project/program. When I run the program the SDR dongle is detected but it doesn't display anything when I press the doorbell (the image shows what I see after running the program and pressing the doorbell). I have also tried Honeywell Activelink (FSK) aka [116], so I have tried both 115 and 116 decode protocols.

rtf_433 IoT & embedded device signal receiving https://github.com/merbanan/rtl_433