adalight_ws2812 VS Adalight-FastLED

I want to up the baud rate to 250k for my arduino nano that I’m using as a controller for ambilight. The sketch i’m uploading is link

Thank you again. Yes, I could have googled more. I have been using this guide: https://imgur.com/a/piES2Dm and that relies on this https://github.com/Wifsimster/adalight_ws2812 sketch... the guide says to do 99 pixels but i do not know if that is a limit within the arduino or prizmatik. I have the highest density per meter strips and 99 seems to fit perfectly around. I do not understand why 99 is some magic number, maybe i could double it and increase brightness that way by wrapping it around twice?

and is using this version of adalight: https://github.com/Wifsimster/adalight_ws2812

Software and Hardware used: I am using Adalight Fastled (https://github.com/dmadison/Adalight-FastLED) with a WS2812B strip.

Run Adalight with Prismatik.

The sketch I used for the DIY Ambilight can be found here: https://github.com/dmadison/Adalight-FastLED/blob/master/Arduino/LEDstream_FastLED/LEDstream_FastLED.ino

Use this code instead. Define the LED type, data, and clock pins at the top.

Of course, here it is: https://github.com/dmadison/Adalight-FastLED

I have uploaded a sketch Adalight-FastLED to an Arduino Mega. The following description is the requirement for my c# app that is using a slightly modified Ardity to send byte[] instead of strings to the Arduino.

another warning: the off the shelf kits come with a relatively low baked-in baudrate (115200, but confirm with your seller), this might limit your LED framerate, read this, so don't set your software to 360-noscope-fps capture right away... so either you are fine with what you'll get and you leave it at that or you want a higher rate, in which case you'll need to flash it with any other arduino ambilight sketch (such as this) with values that work for your board (any arduino ambilight tutorial on the subject will do)

I used this: https://github.com/dmadison/Adalight-FastLED If you need any further help, dm me. I'm electrician, so I didn't need to learn how the electronics work.