Sherpa_Mini-Extruder VS VoronUsers

I had a microswiss setup before this. I'm sure you can edit the files to be able to mount one, but unfortunately, the MS setup is heavy. What I did for this build is use the toolhead from Clehn8ok's EnderWire conversion, but I edited the extruder mount to be able to use a Sherpa Mini.

I say give it time and see if your mood improves. Otherwise look into the Mini Sherpa (https://github.com/Annex-Engineering/Sherpa_Mini-Extruder)

The Sherpa mini is an open source extruder (https://github.com/Annex-Engineering/Sherpa_Mini-Extruder) you could print and use with the gear and shaft from a original or clone bmg. It is very lightweight and realiable extruder even with flexible filaments.

Here is the Klipper Config from Annex Engineering for the Sherpa Mini: https://github.com/Annex-Engineering/Sherpa_Mini-Extruder/blob/master/Klipper_Config_Block.txt

For anyone that might find this post, it ended being a retraction issue. I am using a Sherpa Mini, and the recommended maximum retraction speed is 30 mm/s, which I had set to 50 mm/s.

In my opinion the Mini AB is terrible. I have the mosquito running with a Sherpa Mini extruder and cowling of my own design. But the mini after sherpa works ok. If you can't find another cowling that works, I could modify mine so it fits the larger mosquito. There are other designs out there like the V0VO

https://github.com/Annex-Engineering/Sherpa_Mini-Extruder/blob/master/Klipper_Config_Block.txt for the mini, https://github.com/Annex-Engineering/Sherpa-Extruder/blob/master/Tall_Bowden_Variant/Klipper_Config_Block.txt for the regular Sherpa. Both are in the 0.3A range. So, change the run_current to 0.35 and hold_current to 0.3 and try again.