Sherpa_Mini-Extruder VS VoronUsers

I had a microswiss setup before this. I'm sure you can edit the files to be able to mount one, but unfortunately, the MS setup is heavy. What I did for this build is use the toolhead from Clehn8ok's EnderWire conversion, but I edited the extruder mount to be able to use a Sherpa Mini.

I say give it time and see if your mood improves. Otherwise look into the Mini Sherpa (https://github.com/Annex-Engineering/Sherpa_Mini-Extruder)

The Sherpa mini is an open source extruder (https://github.com/Annex-Engineering/Sherpa_Mini-Extruder) you could print and use with the gear and shaft from a original or clone bmg. It is very lightweight and realiable extruder even with flexible filaments.

Here is the Klipper Config from Annex Engineering for the Sherpa Mini: https://github.com/Annex-Engineering/Sherpa_Mini-Extruder/blob/master/Klipper_Config_Block.txt

For anyone that might find this post, it ended being a retraction issue. I am using a Sherpa Mini, and the recommended maximum retraction speed is 30 mm/s, which I had set to 50 mm/s.

In my opinion the Mini AB is terrible. I have the mosquito running with a Sherpa Mini extruder and cowling of my own design. But the mini after sherpa works ok. If you can't find another cowling that works, I could modify mine so it fits the larger mosquito. There are other designs out there like the V0VO

https://github.com/Annex-Engineering/Sherpa_Mini-Extruder/blob/master/Klipper_Config_Block.txt for the mini, https://github.com/Annex-Engineering/Sherpa-Extruder/blob/master/Tall_Bowden_Variant/Klipper_Config_Block.txt for the regular Sherpa. Both are in the 0.3A range. So, change the run_current to 0.35 and hold_current to 0.3 and try again.

270º Clamping Hinges

Hotend is a Triangle Labs CHC Pro. Extruder setup is a mixture of a couple 😅 -mod of Mantis Toolhead to mount on MGN9C

Stealth skirts by Maverick

Those are a duct remix of this design, it is not yet posted since I need to install my wires to make sure no changes are needed. It will probably be uploaded in the next week.

I'm running a Chainflex umbilical cable + a beacon probe USB cable along the prebowden. I'm thinking about running the Bowden guide to help, I'm not pinching anything when I home the printer, but I'm looking to keep everything up and out of the way. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Galvanic/Bowden_Tube_Guide

Here is a good cfg to automate the fans

basically copied and pasted from here: VoronUsers/bedfans.cfg at master · VoronDesign/VoronUsers · GitHub with printer specific info bellow

Why don't you submit this to the vetted mods repository? https://github.com/voronDesign/voronusers

I swapped to these magnetic bottom panels and they are awesome!

I noticed that you mentioned being annoyed by the cable management (or lack of it) in the kit, which I think is probably not uncommon with many kits with some exceptions (LDO looks nice). That bothered me also, so I'm also working on something to help with cable management, which may also work with the Trident (a remix of these cable ducts).