LenovoLegionToolkit VS Custom-Resolution-Utility-ToastyX

Because you can always disable it and it doesn't have unnecessary sh*t. You can always install Lenovo Legion Toolkit.

Our laptop is not totally supported by Lenovo Legion Toolkit, and the main dev said he only want to support Legion & IdeaPad gaming, but he's open to pull requests to add support to more models.

I haven't seen that before, but you could consider using https://github.com/BartoszCichecki/LenovoLegionToolkit which is a lightweight replacement for vantage.

I use LLT for automatic resolution switching when a game launches but in case that program doesn't run on your setup here's another way that uses hotkeys to switch resolutions.

Standard procedure to uninstall McAfee and revert to Windows Defender along with other bloat like OneDrive and you can replace Lenovo Advantage with lightweight Lenovo Legion Toolkit.

Custom Resolution Utility.

hmm.. it should be there.. but You can enable a custom resolution pretty easy. That's what I do with my old 60hz monitors ! (my tv can do 137hz).. for basic, nvidia/customize then enable a custom resolution.. or " Custom Resolution Utility aka CRU and just program a few. very simple

Link here: https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU

May I know what are the possible solutions to this without replacing the 5D10R41286 LCD Display, as well as the maximum range of the monitors refresh rate at 1920x1080 using CRU. https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU

I've recently went down this rabbit hole myself as well and found Custom Resolution Utility (CRU) [1] to be an efficient EDID editor.

[1] https://www.monitortests.com/forum/Thread-Custom-Resolution-...

What I've Tried So Far: I've tried to download CRU (https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU) and I have tinkered a bit with one of the monitor parameters. I have faced some black screens and I have reverted all the changes. I have seek help online, but none of the solutions seems to work for me. Both monitors are connected using DisplayPort, and they work fine individually with their native resolutions and refresh rates.

To overcome this limitation, I downloaded the CRU tool and created a custom resolution of 1440p @ 59.9Hz, and everything started working perfectly! At 1440p, the studio display looked just right in terms of scaling, and it was sharp enough for everyday use. I also tested some gaming, and the 3070 performance was more than sufficient; 1440p at ultra settings consistently stayed at 60Hz!

I downloaded custom resolution utility here https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU , theres also another website https://custom-resolution-utility.en.lo4d.com/windows IDK which one is legit, is custom resolution malware? or is it safe? for all of you saying just use the Nvidia or AMD settings im on a laptop and my Nvidia control panel doesnt have Resolution tab

Custom Resolution Utility(https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU)

I had the exact same issue. Just use this Custom Resolution Utility - https://www.monitortests.com/forum/Thread-Custom-Resolution-Utility-CRU - You will want to create a custom resolution that is 2880x1660. You can use this to figure out how to use the software (scroll down to A Little Outside Assistance...) - https://www.alphr.com/set-custom-resolution-windows-10/