KlipperWrt VS klipper-web-control-docker

Hey guys, I've been following this tutorial for converting a creality wifi box to run klipper: https://github.com/ihrapsa/KlipperWrt

On a Laptop, log into the Printers Wifi (It will be named CXSWBox-12345678ABCDEF or similar), the password is "12345678". You will get an IP address via DHCP. The Wifi Boards web interface is reachable at 10.10.10.254 with username "admin" and password "admin". Go to Administration > Upload Firmware. Choose one one of the -factory images at https://github.com/ihrapsa/KlipperWrt/tree/main/Firmware/OpenWrt_snapshot, depending if you want to run fluidd or mainsail (Comparison is here: https://www.youtube.com/watch?v=BHVVcjtWTyA). Upload the image, you will get a message "Not a valid firmware". Go to http://10.10.10.254/adm/system_command.shtml and enter mv /var/tmpFW /media/mmcblk0p1/cxsw_update.tar.bz2 and for the next command reboot. Then wait for a KlipperWrt Wifi to show up. Connect to it, use the static IP 192.168.1.23 with netmask 255.255.255.0. The web interface is available at 192.168.1.1:81.

I recall that Android phones are unreliable for Klipper with all of their built in power saving features that will interrupt prints. Any device that runs Linux should be able to run Klipper. A VM on a Mac or PC should be able to do it as long as you can reliably forward the virtual serial port. Running on a router is possible with KlipperWRT. https://github.com/ihrapsa/KlipperWrt

Instructions from Iona Rapsa's Github - https://github.com/ihrapsa/KlipperWrt

I followed this guide https://github.com/ihrapsa/KlipperWrt (used the openwrt image compiled by ihrapsa).

I bought an Ender 3 v2 for my son as a birthday a couple of weeks ago, it came with the Creality cloud box (as a free gift). The cloud box was promptly flashed to OpenWrt and Klipper installed using guidance from https://github.com/ihrapsa/KlipperWrt.

git clone https://github.com/dimalo/klipper-web-control-docker.git klipper cd klipper docker compose up

I'm using a version of this repo: https://github.com/dimalo/klipper-web-control-docker

After searching on the Internet, I found one issue ticket mentioning this. https://github.com/dimalo/klipper-web-control-docker/issues/41

Hi! I've recently got an Intel NUC and decided to go klipper on fluidd. I used this guide. But unfortunately it didn't work, I'm getting the "mcu unable to connect" in fluid and the below logs in klipper. Any ideas?

This far all smooth. Now I am trying to install the fluidd and klipper on docker using https://github.com/dimalo/klipper-web-control-docker

I am trying to run the stack of Klipper/moonraker/Mainsail via docker. I found this and can get it running. My issue is that the various configs are not visible in the Mainsail interface. Does anyone have an idea or a different way to set up via docker?

If you don't want to use Debian based distro and you are okay with using either Moonsail or Fluidd, I recommend to use this docker image.

Here's what the dimalo container does: https://github.com/dimalo/klipper-web-control-docker/blob/main/klipper/Dockerfile

Here's my config, with all the unrelated macros removed. Apart from CHANGE_FILAMENT which I edited, all macros are pretty much untouched and come from here